Vmax Black Ice-olator



The CNC machined ICE-OLATOR features a one piece 9.75 mm high tech heat resistant plastic block designed to reduce the temperature of the intake manifold allowing a cooler air charge resulting in increased power. HP gains with the ICE-OLATOR are approximately 18-20 Installation takes about 15-20 min.

You reuse your existing gasket on the bottom side of the ICE-OLATOR and bolts. You will need to purchase Permatex Right Stuff from your local auto parts store to complete the installation. Begin with putting your gasket in place and applying The Right Stuff around each port on the top side.

Next begin snugly bolting the ICE-OLATOR in by starting with the furthest rear and front bolts. Then work your way through the rest of the bolts evenly hand tightening each. Make sure you don’t over tighten.

Note: The VMAX ICE-OLATOR is recommended to be used with an aftermarket cold air intake for top end gains. Product Features 9.75mm high tech resistant plastic block Reduces the temperature of the intake manifold Installs within 15-20 minutes 18-20 horsepower gain.



Clear selection

Product Description

LLT & LY7 Engine Compatability Chart

Additional Information

Weight 1 lbs
Dimensions 12 x 6 x 1 in

GM LLT V6 Direct Injection engines, GM LY7 V6 Port Injection engines


There are no reviews yet.

Be the first to review “Vmax Black Ice-olator”

Your email address will not be published. Required fields are marked *

Contact Us

We're not around right now. But you can send us an email and we'll get back to you, asap.

Not readable? Change text. captcha txt

Start typing and press Enter to search

VMAX Velocity Ring